|
|
|
| Low Pressure Direct Fired Production Unit |
Vesco, Inc. is producing a low pressure direct
fired production unit.
The unit can be used on wells that require
both a separator and a heater treater. This
36" X 10' horizontal production unit
allows you operate one unit instead of two.
The unit operates at a maximum working pressure
of 250 psi, while the burner is rated at
350,000 BTU/HR.
The actual amount of total fluid
which can
be effectively treated depends
ultimately
on the oil/water ratio, oil viscosity,
treating
temperature, oil and water densities,
chemical
reactions and periodic peak flow
rates. The
actual gas capacity depends on
the gas gravity,
gas temperature, operating pressure,
and
the magnitude of the pressure
cut necessary
to produce the well.
Oil and Water Box
The use of an oil dam and adjustable
water
weir allows effective control
of both oil
and water levels and eliminates
problems
associated with interface control
in small-diameter
horizontal vessels. The oil flows
over the
oil dam into the oil box and
the water flows
through the adjustable weir nipple.
The weir
is adjustable to allow for variations
in
oil/water specific gravity or
oil retention
time.
Gas Dome and Dryer
The gas leaves the production
unit through
a mist extractor installed in
the gas dome.
A back-pressure valve or the
sales line pressure
controls the vessel operating
pressure. A
gas dryer permits instrument
and fuel gas
to be taken out of the main stream
at the
highest possible point, hence
minimizing
liquid carryover to the fuel
and instrument
systems.
Vesco, Inc. became Northwest Oklahoma's only code fabrication
facility in 2002, obtaining 2 code stamps.
The ASME "U" code stamp certifies
that our new code fabrication is built to
ASME code specifications and The National
Board "R" code stamp allows us
to make repairs to code vessels under The
National Board standards.
Vesco, Inc. usually has a selection
of code
separators fabricated, tested,
inspected
and painted in stock. If you
are looking
for an A.S.M.E. code pressure
vessel, be
sure to let Vesco, Inc. meet
your needs.
Contact Vesco, Inc for all of your A.S.M.E. code fabrication needs. If you want to check our
stock, receive a quote or just
ask a few
questions, please contact us
at (580) 256-2569 or e-mail us!
|
Click on picture to enlarge pictures!!
P.O. Box 246
Woodward, Oklahoma USA 73802
Phone 580-256-2569
Fax 580-256-4262
|
|
